Jetson Rave - Get Started with Your Hoverboard; Charging the Battery; Understanding Indicator Lights; How to Recalibrate Your Hoverboard

*Adults must assist children in the initial adjustment procedures of the product.
1. Get Started
1.1 Charging the Battery
1.2 Indicator Lights
1.3 How to Recalibrate
• Only use the included charger
• Plug the charger into the wall before the Charging Port
• Don’t turn on the Rave while it’s charging
• Charge the battery until it is fully charged - up to 3 hours
- Charging
- Charge Complete
< 20% 20-49% 50% +Percentage
Follow these 3 simple steps...
1. Place the Rave on a flat, level surface.
2. Hold the Power Button (for about 5 seconds) until you are notified
of a successful recalibration.
3. Restart the Rave by turning it off and then on.
Hold for 5 seconds
Indicator Light
Battery
Indicator Light
Status
Light
Power
Light
Balance
Light
Warning: The Rave will automatically turn off once the battery power
goes below 10% as a safety precaution.
Status Light: If this light turns red or if you are having issues with
the Rave, you may need to recalibrate it.
Balance Light: Active Balance Technology is on, which levels the Rave
as you ride.
Power Light: The Rave is powered on.