26 PI-120 March 2020
7. Pull shaft/bearing assembly from body using four jacking setscrews
or Jetstream puller kit (PN 67540) and inspect shaft and/or bearings
for damage or improper operation.
8. To replace bearings, press bearings off shaft using an arbor press or
Jetstream puller. To prevent shaft and/or bearing damage, use only
special installation and removal tools supplied by Jetstream. Contact
your local Jetstream representative to obtain the proper tools
(PN 67540). Press new bearings onto shaft using arbor press with
Jetstream spacers. Make sure bearing orientation is correct (see im-
age). Note that wide outer race with markings on both bearings will
face outward away from each other.
Removing Shaft
To Next Page
Loading...