Need help?Do you have a question about the Jetvent Fans JVEC-LP and is the answer not in the manual?
General| Brand | Jetvent Fans |
|---|---|
| Model | JVEC-LP |
| Category | Fan |
| Language | English |
Covers risks of fire, electric shock, injury, and general operational precautions.
Addresses residual electric current, voltage presence, and wiring safety.
Covers structural mounting requirements and hazards from rotating equipment.
Defines the product's intended applications and lists prohibited uses.
Details precautions for hot surfaces and automatic fan restart.
Lists essential components for a successful installation.
Lists the components typically included in the package.
Details model specifications including width, weight, voltage, RPM, and CFM.
Factors to consider for planning fan placement and installation.
Describes mounting points and methods for hanging the fan.
Covers standard and sound-sensitive installation techniques.
Visual examples illustrating correct and incorrect fan placement.
Details motor voltage range, phase, frequency, and connection diagram.
Lists available speed control signal options for the fans.
Wiring diagram for connecting a 10k Ohm potentiometer.
Wiring diagram for connecting a 0-10V DC analog signal.
Wiring diagram for connecting a 4-20mA current signal.
Wiring diagram for connecting a MODBUS RS-485 digital signal.
Describes daisy chain setup, repeater use, and connection topology.
Guidelines for conduit separation and selecting appropriate cable types.
Instructions on connecting the communication cable shield to ground.
Details on installing 120 ohm resistors for proper termination.
Diagram and instructions for connecting the first sensor.
Diagram and instructions for connecting the second sensor.
Requirement for installing a jumper wire to enable speed control signals.
Optional wiring diagram for integrating fans with a fire alarm system.
To Next Page
