Need help?Do you have a question about the Jeulin CL 3020 and is the answer not in the manual?
Specifies the measurement ranges for DC voltage from 400mV to 1000V.
Details the minimum measurable unit for DC voltage, which is 100µV.
Provides accuracy specifications for DC voltage measurements.
States the input impedance for DC voltage measurements as 10 MΩ.
Defines the overload protection limits for DC voltage measurements.
Specifies the measurement ranges for AC voltage from 400mV to 750V.
Details the minimum measurable unit for AC voltage, which is 100µV.
Provides accuracy specifications for AC voltage measurements.
States the input impedance for AC voltage measurements as 10 MΩ.
Defines the overload protection limits for AC voltage measurements.
Specifies the measurement ranges for DC current from 400µA to 20A.
Provides accuracy specifications for DC current measurements.
Details input protection for DC current measurements, including fuse specifications.
Specifies the measurement ranges for AC current from 400µA to 20A.
Provides accuracy specifications for AC current measurements.
Details input protection for AC current measurements, including fuse specifications.
Specifies the measurement ranges for resistance from 400Ω to 400MΩ.
Provides accuracy specifications for resistance measurements across various ranges.
Specifies the open circuit voltage for resistance measurements.
Defines the overload protection limits for resistance measurements.
Describes the audible signal for continuity when resistance is below a threshold.
Defines the overload protection limits for continuity testing.
Specifies the test current used for diode testing.
Provides accuracy specifications for diode testing.
Specifies the open circuit voltage for diode testing.
Defines the overload protection limits for diode testing.
Specifies the measurement ranges for capacitance from 4nF to 400µF.
Provides accuracy specifications for capacitance measurements across various ranges.
Specifies the measurement ranges for inductance from 4mH to 40H.
Provides accuracy specifications for inductance measurements across various ranges.
Details the test frequencies used for inductance measurements depending on the range.
Specifies the measurement ranges for frequency from 4kHz to 4000kHz.
Provides accuracy specifications for frequency measurements.
Details the minimum sensitivity required for frequency measurements.
Defines the overload protection limits for frequency measurements.
Specifies the voltage thresholds for high and low logic levels.
Describes the buzzer indication for low logic levels.
Details the frequency response for logic level detection.
Specifies the minimum detectable pulse width for logic signals.
Defines the duty cycle limits for pulse detection in logic testing.
Defines the overload protection limits for logic testing.
Specifies the measurement ranges for temperature from -20°C to +750°C.
Details the resolution for temperature measurements, which is 1°C.
Provides accuracy specifications for temperature measurements at different ranges.
Explains how to activate and use the function to retain the maximum measured value.
Provides step-by-step instructions for measuring capacitance and inductance.
Details the procedure for performing voltage measurements, including probe connections.
Guides on how to perform current measurements, including probe connections.
Outlines the steps for measuring resistance and continuity.
Details the procedure for conducting a diode test, including probe reversal.
Provides instructions for measuring frequency using the device.
Explains the procedure for measuring capacitance using the Cx socket.
Details how to perform logic measurements and interpret the display symbols.
Provides instructions for measuring temperature using a K-type thermocouple.
Instructions on how to replace the device's 9-volt battery.
Guides on how to access and replace the internal fuses (F1 and F2).
Details warranty, contact information, and procedures for repairs or spare parts.
Information on expert availability and contact methods for technical support.
Provides the web address for online assistance and FAQs.
Lists addresses and phone numbers for Jeulin's technical support in France and internationally.
General| Brand | Jeulin |
|---|---|
| Model | CL 3020 |
| Category | Multimeter |
| Language | English |
To Next Page