Need help?Do you have a question about the JFA Electronicos VS5HI and is the answer not in the manual?
General| Category | Measuring Instruments |
|---|---|
| Model | VS5HI |
| Manufacturer | JFA Electronicos |
| Frequency | 50/60Hz |
| Protection | Overload, Short Circuit |
Describes the device's HOL (Hold), LIG (ON), and OFF selector modes.
Indicates the switch for selecting between LOW and HIGH voltage measurements.
Details the five output terminals for remote control functions.
Specifies the input terminal for high voltage from the battery bank (up to 500V).
Identifies the GND terminal for ground connection.
Points to the terminal for receiving remote control input signals.
Marks the terminal for low voltage input, typically +12V.
Explains the HOL/LIG/OFF and 12V/HV switch settings for controlling device functions.
Details how the device operates in HOL, LIG, and DES modes with player and outputs.
Provides voltage measurement ranges: Low to 17V, High to 500V.
Lists current at output, voltage protection thresholds, and device dimensions.
Advises caution with high voltage installation and using undamaged cables.
To Next Page