JFE Advantech RINKO FT - Page 49

[Appendix 3] 2/2
Power ON RINKO FT
Start
Wait 5 seconds
Command “querys”
“preheat”
“normal”
Command “stdo”
Store T and DO
by host controller
Command “qs”
No response
Power OFF RINKO FT
End
“OK”
Repeat sampling?
Yes
No
Example 2: Sample T and DO at 5 s (or less) of sampling interval.
In this case, RINKO FT is necessary to be continuously powered on until the observation is finished as
shown in the flowchart below.
Minimum sampling interval is 1s.