7
Caution
Do not apply strong force or impact on the sensor.
It can lead to damage, which may cause injury and seepage of water into the instrument.
Do not hang by holding only the lead wire.
It can lead to a broken wire or damaged instrument.
Make sure to insert the connector completely up to its base.
It may cause seeping of water into the instrument.
Do not leave the instrument in a place with high temperature (e.g. under direct sunlight)
for a long time.
It can accelerate the degradation of the oxygen detection film.
When attaching, make sure to tighten the screw all the way.
Loosely attached screws can compromise the water-proof property and may cause seeping of
water into the instrument.
To Next Page
Loading...