Need help?Do you have a question about the JG Maker Artist-D and is the answer not in the manual?
General| Print Technology | FDM (Fused Deposition Modeling) |
|---|---|
| Layer Resolution | 0.05-0.3 mm |
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Supported Filament Types | PLA, ABS, PETG, TPU |
| Max Print Speed | 150 mm/s |
| Connectivity | USB, SD Card |
| Frame Material | Aluminum |
| Number of Extruders | 1 |
| Heated Bed | Yes |
| Bed Temperature | up to 100°C |
| Nozzle Temperature | 260°C |
| Power Supply | 24V |
| Display | Touch Screen |
| Print Surface | Glass |
Essential safety instructions for operating the 3D printer to prevent injury and damage.
Steps for installing the gantry onto the printer's base and securing it.
Procedure for attaching the Z-axis tensioning idler to the top of the gantry.
Steps to ensure the print bed is properly leveled for optimal printing.
Guide on how to load filament into the extruder for printing.
Instructions for installing and configuring slicing software like Cura for the printer.
Diagnosis and solutions for common printer failures and error messages.
To Next Page