Why does my Jilong Z-RAY I 200 appear a bit soft?
If your Jilong Boat feels a bit soft, it could be due to temperature changes. For instance, if you inflated the boat when it was 35°C (95°F) and the temperature drops to 25°C (77°F) overnight, the pressure inside the boat might decrease, making it feel softer. Also, make sure that all valve caps are tightened properly.
What to do if Jilong Z-RAY I 200 has little holes or puncture?
To fix little holes or punctures in your Jilong Boat, first locate the leak. Clean the area around the leak to remove dirt. Cut a round piece of repair material larger than the hole. Trace the patch area, apply adhesive to the patch and the boat, then firmly press the patch onto the damaged area. Let it dry for 12 hours, then apply glue around the edges for a complete seal and let that dry for 4 hours.
How to check Jilong Z-RAY I 200 Boat for leak?
If your Jilong Boat appears a bit soft, start by checking the valve caps to ensure they are not loose. If they are tighten them. If the valve caps are not loose, you need to find the leak. Scan the boat or flip it over to closely check the outside. For pinpointing the leak spray mild soapy water over the suspicious areas. Any leak will produce bubbles. Also, check valves system for leaks.
To Next Page
General
