What to do if the JIMTEN Plumbing Product lifting station does not start?
If the lifting station doesn't start, it could be due to a few reasons. First, ensure the appliance is correctly connected. Next, verify that the electricity supply is correct. Lastly, if the electrical protection has been activated, wait about 20 minutes for the motor to cool down.
Why does my JIMTEN Plumbing Product motor work but not discharge properly?
If the motor is running but not discharging or doing so slowly, there may be a blockage in the drainage pipe. Try cleaning the drainage pipe to resolve this issue.
What to do if my JIMTEN Plumbing Product motor does not stop?
If the motor doesn't stop, several factors could be the cause. Consider whether the drainage pipe has excess height or length, or if there's a loss of power due to too many elbows. Additionally, check for a blockage in the discharge pipe or obstruction due to limescale. Clean the discharge pipe or carry out the descaling process. If none of these actions solve the problem, it may be caused by a malfunction of the microswitch, and you should contact Technical Assistance.
What to do if the differential switch trips on my JIMTEN Plumbing Product?
If the differential switch trips, it is most likely because the motor’s earth connection is defective. As the motor is broken you should contact Technical Assistance.
Why does the JIMTEN Plumbing Product shower basin not drain well?
If the shower basin doesn't drain well, it could be due to a possible obstruction of the drain. Try cleaning the drainage piping. Also, if the shower basin drain is siphonic, it might be creating plunging of air during drainage; in this case, remove the siphon from the shower basin valve.
What to do if the JIMTEN Plumbing Product motor buzzes but doesn't turn?
If the motor buzzes but doesn't turn, the turbine may be blocked by foreign matter. You should see maintenance operations (disassembly and extraction of the motor, page 11).
What causes strange noises from my JIMTEN Plumbing Product motor?
A strange noise when the motor is working is usually caused by an obstruction or blockage from foreign matter that has fallen into the unit. Extract the matter from inside the unit. (See motor disassembly and extraction 7.3).
What to do if my JIMTEN Plumbing Product motor doesn't work with one of the connected sanitary fixtures?
If the motor isn't working with one of the connected sanitary fixtures, the auxiliary connections might be obstructed, or the non-return valve could be blocked. Try cleaning the auxiliary connection section of pipe. It could also be due to a lack of aeration or gradient in the auxiliary connection; in this case, provide the installation with secondary ventilation or install an aeration valve (Jimten A-69 type). If the problem persists, it may be caused by a malfunction of the microswitch, so reconsider the installation and contact Technical Assistance.
What to do if the JIMTEN Plumbing Product motor starts and stops indiscriminately after draining?
If the motor starts up and stops indiscriminately after draining, it is likely due to a leak from the non-return valve or loss of water from one of the connected sanitary fixtures. Try cleaning the discharge pipe’s non-return valve and check and replace the joints of the taps of the connected sanitary fixtures.
Why does my JIMTEN Plumbing Product motor start repeatedly before stopping?
If the motor starts up repeatedly before stopping for good, it's likely due to water returning to the lifting station because the non-return valve isn't working properly. Try carrying out a number of discharges with clean water and clean the non-return valve.
Comprehensive safety advice and operating instructions for user reference.
Guidelines for piping, bends, frost protection, and connections for optimal setup.
Covers issues like unit not starting, motor buzzes, or indiscriminate starting/stopping.
Addresses slow discharge, motor not discharging, or water returning to the basin.
General| Brand | JIMTEN |
|---|---|
| Model | CICLON LS EB-705 |
| Category | Plumbing Product |
| Language | English |
To Next Page