JINJUNYE Aquajack 600

Questions and Answers

R
Robert GillespieAug 6, 2025
Why is my JINJUNYE Aquajack 600 not picking up debris?
- J
  Jose BarrettAug 7, 2025
  If your JINJUNYE Swimming Pool Vacuum isn't picking up debris, several factors could be at play: * A low battery may be the culprit. If so, charge the robot. * The impeller might be stuck. In this case, turn off the power and check the impeller's rotation. If it's indeed stuck, contact your dealer. * The glove box could be full. If this is the case, clean the glove box and filter cover. * The robot might be blocked by suction from the main pool floor drain. Try turning off the filtration system to resolve this. Making the bottom of the pool flat or trimming the bottom brush strip may also help. Contact your dealer for replacement parts.
A
Andrew HarveyAug 17, 2025
What to do if debris is escaping from my JINJUNYE Aquajack 600?
- K
  Kimberly IngramAug 17, 2025
  If debris is escaping from your JINJUNYE Swimming Pool Vacuum, it could be due to: * A broken suction nozzle valve. If this is the case, contact your dealer for replacement parts and instructions. * A damaged filter cover. If so, replace it with a new one, contacting your dealer for replacement parts.
J
Jordan BrownAug 27, 2025
Why does the JINJUNYE Aquajack 600 Swimming Pool Vacuum charger always show a red light?
- J
  Jimmy MyersAug 27, 2025
  If the charger for your JINJUNYE Swimming Pool Vacuum constantly shows a red light and doesn't turn green after 8 hours, potential causes include: * The robot not being dry, leading to a short circuit at the contact point, allowing it to function without water. * Debris like wet hair at the contact point, causing a short circuit. * A damaged circuit board. * Battery damage.

Summary

Safety and Warnings

Charger Safety

Guidelines for safe use and handling of the original charger for indoor use.

Battery Disposal

Instructions for proper disposal of the lithium battery and associated safety precautions.

Assembly and Operation

Product Assembly

Instructions for assembling the various components of the robotic pool cleaner.

Initial Charging and Setup

Steps for charging the robot for the first time and preparing it for operation.

Usage Procedures

Powering On the Robot

Detailed steps for placing the robot in the pool and initiating its cleaning cycle.

Garbage Disposal Management

Instructions on how to remove and empty the collected debris from the robot's filter.

Maintenance and Storage

Impeller Maintenance and Replacement

Procedures for maintaining or replacing the robot's impeller unit.

Wheel Maintenance and Replacement

Guidance on maintaining or replacing the robot's wheels for optimal performance.

Battery Management

Battery Replacement Procedure

Step-by-step guide for safely removing and replacing the robot's battery pack.

Troubleshooting Guide