30" OSCILLATING PEDESTAL FAN
OWNER'S MANUAL
AIR
CIRCULATOR
CAUTION
WARNING
RULES FOR SAFE OPERATION
:
:
:
Read and follow all instructions before operating fan.
Do not use fan if any part is damaged or missing.
- To reduce the risk of fire or electrical shock, do not expose to water or rain.
- To reduce the risk of fire or electrical shock, do not use this fan with any solid state
speed control device.
- Automatically operated device - To reduce the risk of injury, disconnect from power
supply before servicing.
- If the power supply cord is damaged, contact your local service centre or a qualified
electrician to install an appropriate replacement cord to prevent any injury or damage.
- The appliance does not apply to be used in locations where special conditions prevail,
such as the presence of a corrosive or explosive atmosphere ( dust, vapour or gas ).
- This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
1. Never insert fingers or any other objects through the grill guard when fan is in
operation.
2. Disconnect the fan from its power source when moving from one location to another.
3. Disconnect the fan from its power source when removing guards for cleaning.
4. Be sure fan is on a stable, flat surface when in operation.
5. Do not use fan in windows. Rain and moisture may create electrical hazard.
6. Close supervision is necessary when this fan is used near children, the elderly and
pets.
7. Do not place the fan near an open flame, cooking or heating appliance, or hot surface.
8. This fan should not be operated outside.
Do not alter the fan's assembly.
Be sure that both front and rear guard screws are completely tightened in
locking position before operation.
CAUTION:
WARNING:
COLUMN ASSEMBLY INSTRUCTIONS:
1. Attach coupling to the base with the screws as shown.
2. Loosen set k on the outer tube coupling and extend inner tube to desired height
tighten.
Set knob must be fully tightened before assembling the motor to the inner
tube.
nob
CAUTION:
FO-75S1fOL(2)
MODEL
10307
1
To Next Page
Need help?
General