Jinma Tractor Introductory User Guide July 2007 Page 33
Grease: There are various locations on the tractor which need to be greased
using a grease gun. Use good quality grease. In the US that generally means a
molybdenum or lithium based grease. Lithium grease or lithium grease with
molybdenum should be fine.
What is calcium based grease that is referenced in the Jinma manual? Don’t use
it! It is of a lesser quality then lithium and molybdenum grease.
Grease Nipples: Each of the locations to be greased has a grease nipple. There
are 7 grease nipples on the Front Axle and Steering System assembly. There are
4 more grease nipples on the underside of the tractor where the brake/clutch
pedals rotate. There are 5 more grease nipples on the back end of the tractor (2 on
the axles, 1 on each 3pt. Linkage). Generally the grease at each location is full
when the grease begins leaking out the gun/nipple.
Hydraulic System
The reservoir for the hydraulic fluid is under the driver’s seat. If
the seat is moved forward, the fill plug can be seen and accessed.
The large bolt has a dip stick attached (level to the line on the dip
stick when the bolt is fully turned in). The reservoir holds about 2
.5 gallons of hydraulic fluid.
Hydraulic Fluid: Use a good quality lightweight hydraulic fluid.
You may be able to find it at some discount stores and auto parts
stores, but farm equipment places are more likely to carry it.
Standard hydraulic fluid is called tractor hydraulic fluid (THF) and
is acceptable for use; however, a light weight fluid is
recommended.
Grease Nipple
To Next Page
Loading...
