BEFORE
YOU BEGIN INSTALLING
• Turn
off
the audio system.
It
is
also advisable
to disconnect your battery system whenever
performing installation work.
• Before cutting, drilling
or
inserting any screw,
check clearances on both sides
of
the planned
mounting
surface. Also check for any potential
obstacles, such as wiring harnesses, fuel lines,
hydraulic lines, etc. Check both sides
of
the
vessel before cutting any holes.
• Wear protective eyewear at all times
and
a dust
mask
and gloves when drilling or cutting.
mWARNINGI
It
is absolutelyvital
that
your
coaxial speaker
system is connected as shown in
this
manual.
Failure
to
connect
the
system as shown will
result
in
damage
to
your
speakers which
is
NOT
covered
under
warranty.
Do
not
substitute different crossover networks!
mCAUTIONI
While these speakers aredesigned
to
be water
and spray resistant, theyare not designed to
be
submerged
or
to
withstand high-pressure water
spray. Please exercise care when washing your
boat
to
avoid damagingyour speakers. Do not
install
on
submersibles, personal watercraft
or
any
othervessel likely
to
be
underwater at anytime.
Prolonged exposure
to
sound pressure levels in
excess
of
lOOdB
can cause permanent hearing
loss. This high-performance speaker can
exceed this level. Please exercise restraint in its
operation
in
order
to
preserve your ability to
enjoy its fidelity.
When
installing speakers
in
your
vessel, it
is
extremely
important
to
secure
them
firmly. This
applies not only
to
the
speakers themselves,
but
also
any
structure they
are
mounted to.
If
not
firmly attached, the speakers can become
dangerous projectiles in a collision. Please
review the
mounting
information carefully
and
use the supplied marine-grade hardware
to
mount
this product.
TWEETER
PROTECTION
The crossover networks are equipped with
an advanced electronic tweeter protection circuit
designed to minimize the possibility
of
tweeter
failure. This electronic device monitors current
going to the tweeter and will disconnect the
tweeter from the signal when it senses overload.
Should this occur while listening to the audio
system, simply reduce the volume for a few
seconds and the protection circuit will reset
itselfautomatically.
4 I
JL
Audio -
M650-CCX
/
M770-TCX
/
M770-CCX
Owner's
Manual
To Next Page
Loading...
Need help?
General
