EasyManua.ls Logo

JLG 3512 User Manual

JLG 3512
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
An Oshkosh Truck Corporation Company
Operator & Safety
Manual
Keep this manual with machine at all times.
Models
3507, 3508,
3509, 3512,
3513, 4007,
4008, 4009,
4012, 4013
3121851
Revised
August 28, 2012

Table of Contents

Other manuals for JLG 3512

Question and Answer IconNeed help?

Do you have a question about the JLG 3512 and is the answer not in the manual?

JLG 3512 Specifications

General IconGeneral
BrandJLG
Model3512
CategoryConstruction Equipment
LanguageEnglish

Summary

Section 1 - General Safety Practices

Electrical Hazards

Details risks from electrical power lines and safe operating distances to avoid electrocution.

Tip Over Hazard

Covers factors causing tip-over, load capacity limits, ground stability, and safe operation.

Travel Hazard

Discusses hazards during machine movement, including steer modes, clearances, and visibility.

Load Falling Hazard

Explains risks of loads falling from forks or carriage and proper load center alignment.

Lifting Personnel

Provides safety guidelines for lifting personnel using approved work platforms.

Driving Hazards on Slopes

Details safe practices for driving on inclines, including load positioning and gear selection.

Pinch Points and Crush Hazards

Highlights hazardous areas on the machine where crushing or pinching injuries can occur.

Fall Hazard

Covers safe mounting/dismounting procedures and risks of falling from the machine.

Chemical Hazards

Details hazards related to exhaust fumes, flammable fuel, and hydraulic fluid exposure.

Section 2 - Pre-Operation and Controls

Pre-Operation Checks and Inspection

Outlines mandatory checks before operating the telehandler, including the walk-around inspection.

Controls

Provides a detailed overview and explanation of all machine controls, indicators, and their functions.

Section 3 - Operation

Engine Operations

Covers engine starting, troubleshooting, battery boost starting, and normal operation guidelines.

Operating with a Load

Details safe practices for lifting, transporting, and placing loads, including capacity awareness.

Section 4 - Attachments and Hitch Options

Telehandler/Attachment/Fork Capacity

Explains how to determine the maximum load capacity for various machine and attachment configurations.

Use of the Capacity Chart

Step-by-step guide on how to read and apply capacity charts for safe lifting operations.

Attachment Installation

General procedures and safety precautions for installing machine attachments onto the boom.

Section 5 - Emergency Procedures

Emergency Lowering of Boom

Methods for manually lowering the boom in case of electronic or engine failure.

Electronic Control Unit Failure

Manual procedure to retract and lower the boom if the electronic control unit fails.

Engine Failure

Manual procedure to retract and lower the boom when the engine fails.

Section 6 - Lubrication and Maintenance

Fuel System Maintenance

Procedures for checking fuel level and draining the fuel/water separator for system health.

Air Intake System Maintenance

Instructions for checking the air filter restriction indicator and replacing the filter element.

Related product manuals