SECTION 1 - JLG SMART SYSTEM ™ ANALYZER KIT INSTRUCTIONS (1600258 CONTROLLER).
3120442 – JLG Sizzor – 1-7
CHANGING THE MACHINE MODEL WILL SET ALL PERSONALITIES BACK TO THE FACTORY DEFAULT SETTINGS. CHECK THE MACHINE
MODEL ADJUSTMENT CHART FOR THE CORRECT SETTINGS FOR EACH MODEL. IF YOUR MACHINE DOES NOT MATCH THE PROPER
SETTINGS FOR EACH MODEL, ADJUST THE SETTINGS AS NECESSARY IN ACCORDANCE WITH THE CHART.
NOTE: * Unless disabled by machine digit #9 (Refer to Table 1-4).
NOTE: * The LIFT DOWN speeds listed in this chart are for those machines equipped with power LIFT DOWN. To identify
machines equipped with power LIFT DOWN, refer to the Effectivity Page for serial number identification. The LIFT
DOWN speeds listed in this chart are the desired speeds for each model. Actual LIFT DOWN speeds may vary from
machine to machine, as each machine is factory-adjusted for maximum smoothness.
NOTE: * LIFT DOWN speed is non-adjustable on machines equipped with gravity LIFT DOWN.
NOTE: ** JLG strongly recommends that these settings not be changed. Changing these settings may adversely affect the per-
formance of your machine.
To Next Page
Loading...
