Assembly
group
4
SPEED CONTROL
RM
252
FLYBALL GOVERNOR
Special
JLO
Tools
Vibration tachometer 000.15.300.100
DISASSEMBLY
4.1. 1 Remove nut
(21),
washer (18), and cover (17).
2 Disconnect throttle cable noting the hole position for re-assem-
bly. Remove clip
(9)
from linkage and unhook linkage (1).
3
When removing lever (2) note into which of the
5
holes the
governor spring (3) is hooked. To remove lever (2)
,
remove lock
nut (16), spring washer (15), steel washers (14), and plastic
washer (12). Note sequence. Remove screw
(6)
and spring washer
(7)
.
Slide governor lever
(8)
out
of
governor housing.
4
Engine stop contact (10) need not be removed unless it is to be
replaced.
ASSEMBLY
4.2. 1 If engine stop contact (10) has been removed, re-install by
snapping it back into the bore in governor housing. Be sure
recess in flange clears boss
of
crankcase.
2
If stud (13) is loose or has been removed, re-install in
crankcase with thread locking compound.
3 Install governor lever
(8)
with spring washer (7) and screw
(6).
4
Install lever (2) with washers (14,12), spring washer (15), and
new lock nut (16)
.
For precise lock nut tightness please refer
to section "governor adjustment procedure".
5 Install governor spring (3) in appropriate hole of levers 2 and
8.
6
Install governor linkage (1) and secure with new clip
(9).
7
Connect throttle cable.
8
Cover (17) with washer (18) and nut (21) should be installed
after governor has been properly adjusted. Please refer to
corresponding section in this manual.
NOTE
:
Bolts (22)
too
long
or
inserted incorrectly might
jam
the
governor shaft (23). (Observe reach of screw!)
When bolts (22) are inserted correctly, lever must move freely
(ill. II).
13
To Next Page