remotes.jma.es/en
DUPLICATING SEQUENCE
Known fixed code
Rolling, Fixed or unknown code
Simultaneously press buttons 1
and 3 until the red LED starts to
blink. Release and wait until it
turns off.
NOTE:
After performing this step
continue with step 2.
Notes:
After 10 seconds between the steps requiring user action (press any button) the M-BT
remote exits programming mode and requires you to re-start the process.
*When copying a Rolling code remote, the selected and following buttons are recorded.
That is, if button 2 is selected on the duplicate remote, buttons 1, 2 and 3 from the original
are copied on buttons 2, 3 and 4 of the duplicate remote.
On the fixed code remotes, only the original button pressed is copied on the selected
duplicate button.
** If the original remote is BFT or ERREKA, the second section is sent by pressing the
hidden button or by simultaneously pressing 1 and 2 on the original remote.
** If the original remote is FAAC Master/ Genius Amigo, the second section is sent as
follows: Far from the M-BT remote, simultaneously press buttons 1 and 2 (in diagonal)
on the original remote until the LED on the original starts to blink. With the LED blinking,
press again the original remote button to register.
***
Copy modes
Auto: Compatible remote control that should be registered.
Manual: Introduce the number to be added or subtracted to the original.
Button 1: Units. Button 2: Tens. Button 3: Hundreds.
Button 4: Alternates between add and subtract. Rear button. Save and exit.
Clone: Remote control equal to original.
Scanner: This scans the serial numbers. Facing the door press the recorded button.
When the door opens press the rear button.
Wait for the door to close and re-press the recorded button.
When the door opens press the rear button for 5 seconds.
Press buttons 1 and 2 of the remote
control copy simultaneously until
the red led flashes. Release both bu-
ttons and wait for red led to turn off.
1
If the LED starts to blink green the
code has been captured but not
verified. We recommend re-star-
ting the process.
Press the button to be copied (*).
The red LED will light up fixed.
2
If the LED starts to blink red
the code has not been properly
captured. Try to recapture it by
approaching or separating the
original remote.
If the LED turns to fixed red it is
a Rolling Code controller and
needs a second frame.**
Press and hold the original remote
button again until the M-BT
remote turns to fixed green.
Press the desired original remote
button and keep pressing until
the M-BT remote turns to a fixed
green light.
3
If after some time the green LED
turns off, the copy of the fixed
code has finished properly.
If the LED starts to blink red the
Rolling Code cannot be copied.
If the LED changes to slow
flashing, the remote control is
rolling code and has been co-
rrectly decrypted.
Press the button corresponding
to the desired copy mode.***
The LED will go off and the re-
mote control is programmed.
To Previous Page
Loading...
Need help?
General
