How to Glue the Plastic Hinge in
Repeat this Work until all hinges are in,
Make sure the Orientation of the hinge
is 90 degree to the hinge line.
Fill the Hole on one side with the
mixed glue, you can use a Siring
or just a small wood to fill it up a bit,
if the glue goes in around 5mm to the
hole is enough then push all the hinge´s in.
Notice , clean around if the Glue squishing
out and keep a 1 mm gap between both parts
Apply on the plastic hinge until half
way around also Glue same you did already
on the opposite side.
6Ver. 1.0 28.03.2019 Written by F.W
To Next Page
Loading...