(1) cet appareil ne doit pas causer d'interférences nuisibles.
(2) cet appareil doit accepter toute interférence, y compris les interférences pouvant entraîner un
fonctionnement indésirable.
(2) Canadian 20cm RF Exposure Statement (only add the following statement if the product
is used >20cm away from the body)
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and
compliance with RSS-102 RF exposure. Users can obtain Canadian information on RF exposure
and compliance.
L'appareil satisfait à l'exemption des limites d'évaluation de routine de la section 2.5 de RSS 102 et
à la conformité à l'exposition RF RSS-102. Les utilisateurs peuvent obtenir des informations
canadiennes sur l'exposition aux RF et la conformité.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
Cet émetteur ne doit pas être placé au même endroit ou fonctionner en conjonction avec une autre
antenne ou un autre émetteur. Cet équipement doit être installé et utilisé à une distance minimale
de 20 cm entre l’émetteur de radiofréquences et votre corps.
Safety Warning
Read this product manual thoroughly before attempting to use this product. Store the product
manual in a safe location so it may be referenced at any time.
The product can be powered on and off by plugging and unplugging the power cord. The socket
should be located near the product and easily accessible.
This product contains a laser module. Do not disassemble or modify this module without
authorization. Failure to follow this guideline may result in personal injury.
This is a Class 2 laser product. To avoid damage to the eyes, do not stare directly at the beam.
Do not block the air inlet or outlet of the product with any objects when it is projecting an image.
Doing so may result in excessive internal temperatures and damage to the projector.
Do not hit or drop the product from a significant height.
If you encounter an issue with the product, do not attempt to disassemble it without authorization.
Contact professional after-sales personnel to resolve the issue.
If you need to perform repairs on the product, wear a laser face shield with an OD (optical density)
of ≥ 4 and a wavelength range of 440-660nm.
To Next Page
Loading...
