Why is there so much overspray with my JML Paint Sprayer?
If your JML Paint Sprayer is producing too much overspray, it could be due to the gun being too far from the object you're spraying. Try reducing the distance. Alternatively, you might be applying too much painting material; decrease the paint volume setting.
What to do if my JML Paint Sprayer's spray jet pulsates?
If your JML Paint Sprayer's spray jet pulsates, it could be due to several reasons: * The material in the container might be running low, so refill it. * The air filter could be clogged, so clean or replace it. * The spray material might be too viscous; in that case, thin the material by 10%.
How to fix JML Elite when no paint is coming out?
If you're experiencing no painting material being sprayed from your JML Paint Sprayer, here are a few things to check: * The nozzle could be clogged, so clean it. * The suction tube might be clogged, so clean it. * The material volume setting might be too low; increase it. * The suction tube could be loose; re-insert it. * There might be no pressure build-up in the container; tighten the container. * The air filter could be clogged; change it.
Why does the spray pattern run when using my JML Elite?
If your JML Paint Sprayer's spray pattern runs, it's likely because you're applying too much painting material. Try decreasing the paint volume setting.
What causes JML Paint Sprayer to sputter paint?
If your JML Paint Sprayer is sputtering or spitting paint, several issues could be the cause: * The nozzle might be loose; tighten it. * The nozzle could be worn; replace it. * The nozzle seal might be worn; replace it. * There could be material build-up on the air cap and nozzle; clean it.
How to improve coarse atomization with JML Elite?
If the atomization is too coarse with your JML Paint Sprayer, consider the following: * The viscosity of the material might be too high; thin the material by 10%. * The material volume might be too large; decrease the paint volume. * The nozzle could be clogged; clean it. * The air filter might be clogged; clean or change it. * There might be too little pressure build-up in the container; tighten the container and check the seal.
General| Brand | JML |
|---|---|
| Model | Paint Sprayer Elite |
| Category | Paint Sprayer |
| Language | English |
Details hazards related to explosion and fire, with prevention measures.
Explains risks associated with hazardous vapors and their effects on health.
Covers electrical shock hazards and necessary precautions during use.
Addresses explosion hazards due to incompatible materials and necessary precautions.
Provides general safety precautions for operating the paint sprayer.
General guidance on how to operate the paint sprayer effectively.
Details on the spraying technique for an even finish.
Addresses issues where no or minimal paint is being sprayed.
Provides solutions for leaks occurring from the paint sprayer.
Explains causes and solutions for coarse paint atomisation.
Offers fixes for a pulsating spray jet pattern.
To Next Page