Micro-pressure valve:
Lift off the micro-pressure valve (Fig.3).
Separate the two sections by rotating the
lower part anticlockwise and pulling apart
(Fig.4).
Clean using soapy water and a soft cloth,
rinse with clean water and fully dry before
refitting.
To refit, line up the arrow on the lower part
with the arrow on the ‘side’ of the upper
part and fit back together (Fig.5). Rotate the
lower part clockwise to lock together and
refit into the lid.
Note: Cooking could be affected if the
micro-pressure valve is not fitted correctly.
Fig.3
Micro-
pressure
valve
Fig.6
Cleaning & Care
Drip tray:
Check and empty the drip tray at the rear of
the unit after each use (Fig.6).
12
Fig.4 - Locked position
Fig.5 - Unlocked position
Upper
part
Lower
part
To Next Page
Loading...
Need help?
General