Place the
handlebar onto
the handle stem
Tighten the
handlebar knob
4 5
1
8
6
9
4
7
Front wheel
Installation requires adult supervision. To dismantle the scooter, ensure the power is o.
Ensure the power is o and not being ridden before making any adjustments.
Rear wheel
3
2
INSTALLING THE HANDLEBAR
Put down the foot stand
Open the scooter
fully so that the
fold mechanism
holes line up
Place the fold mechanism pin fully
into the hole and tighten the knob.
ATTENTION: Ensure the fold
mechanism pin is correctly inserted
and tightened before riding.
FAMILIARISING YOURSELF WITH YOUR UBER SCOOT S300
2.
1. Throttle
2. Handlebar tightening knob
3. Hand-operated rear brake
4. Handle stem
5. Brake caliper
6. 300W Motor
7. Foot stand
8. Fuse/Reset
9. On/O switch
10. Rechargeable 24V Battery
11. Fold mechanism
1 2
3
10
11
5
To Next Page
Loading...
General