To Next Page
M
mitchell39Sep 23, 2025
How to fix heating sensor fault in Joannes VENUS BA MS 24- 34 Heater?
- MMichelle SpencerSep 23, 2025
If your Joannes Heater is showing a 'Heating sensor fault,' the sensor might be damaged. In this case, replace the sensor.
How to fix heating sensor fault in Joannes VENUS BA MS 24- 34 Heater?
If your Joannes Heater is showing a 'Heating sensor fault,' the sensor might be damaged. In this case, replace the sensor.
What to do if Joannes Heater shows overtemperature protection intervention?
If your Joannes Heater displays an 'Overtemperature protection intervention,' start by checking the heating sensor's position and operation. Next, verify water circulation in the system by inspecting the circulating pump. Finally, vent the system to remove any air.
What to do if Joannes VENUS BA MS 24- 34 has no flame after ignition stage?
To address a 'No flame after ignition stage' issue in your Joannes Heater, check the position of the ionization electrode and replace it if necessary. Also, inspect the burner for any instability. Check the Offset adjustment at minimum power of the gas valve. Clear any obstructions from the flue, fume extraction ducts, air inlet, and terminals. Finally, inspect the trap and clean it if necessary.
What to do if Joannes Heater shows exchanger protection intervention?
If your Joannes Heater displays 'Exchanger protection intervention', check the circulating pump to ensure system water circulation. Also, vent the system to remove any air.
What to do if Joannes VENUS BA MS 24- 34 Heater shows fan fault?
If your Joannes Heater displays 'Fan fault,' check the 3-pin connector wiring for the 230V power supply. Then, check the 4-pin connector wiring for the tachometric signal. Finally, inspect the fan itself for any damage.
What to do if heating sensor detached from pipe in Joannes VENUS BA MS 24- 34?
If the 'Heating sensor detached from pipe' on your Joannes Heater, check the correct positioning and operation of the heating sensor.
What to do if Joannes Heater has card parameter fault?
If your Joannes Heater displays 'Card parameter fault,' check the card parameter and modify it if necessary.
What to do if Joannes Heater has controller fault ABM03D?
If your Joannes Heater displays 'Controller fault ABM03D,' check the ground connection and replace the controller if necessary.
What to do if Joannes Heater has external probe fault?
If your Joannes Heater displays 'External probe fault,' check the wiring or replace the sensor if it's damaged or shorted. If the probe disconnected after activating the sliding temperature, reconnect it or disable the sliding temperature.
What to do if Joannes Heater displays DHW sensor fault?
If the Joannes Heater displays 'DHW sensor fault,' check the wiring or replace the sensor.
General guidelines and requirements for boiler installation.
Guidelines for selecting a suitable location for boiler installation.
Instructions for connecting the boiler's water and heating circuits.
Procedure for connecting the gas supply to the boiler.
Guidelines for safely connecting the boiler to the electrical supply.
Details on connecting fume ducts, including coaxial and separate pipe systems.
Procedures for adjusting boiler settings and parameters.
Steps for converting the boiler to use a different type of gas.
Explanation of fault codes, diagnostic procedures, and error messages.
Table detailing fault codes, their possible causes, and corrective actions.
General