jobmate YLQ6331G-150B

Questions and Answers

V
Victor AndersenAug 4, 2025
Why does my jobmate YLQ6331G-150B Pressure Washer machine pulsate?
- K
  klawsonAug 4, 2025
  Your Jobmate Pressure Washer may be pulsating due to several reasons: there might be air in the inlet hose, so allow the machine to run with the trigger open until regular working pressure resumes. The supply of mains water could be inadequate, so check that the water supply corresponds to specifications required, and avoid using long, thin hoses. The nozzle might be partially blocked, so clean the nozzle. The water filter might be blocked, so clean the filter. Finally, the hose could be kinked, so straighten it out.
E
Emily WrightAug 9, 2025
What to do if my jobmate YLQ6331G-150B Pressure Washer machine does not start?
- J
  Jessica MoranAug 9, 2025
  If your Jobmate Pressure Washer doesn't start, first ensure it's properly plugged in. If it is, try another socket in case the current one is defective. Also, check the fuse and replace it if it has blown. Finally, a defective extension cord could be the issue, so switch off other machines or try using the pressure washer without the extension cord.
J
James BraunAug 15, 2025
What to do if my jobmate YLQ6331G-150B Pressure Washer machine stops?
- P
  pattonemilyAug 15, 2025
  If your Jobmate Pressure Washer stops, first replace the fuse if it has blown. Next, check that the mains voltage corresponds to the specification on the model tag. If the thermal sensor is activated, leave the washer for 5 minutes to cool down. Lastly, if the nozzle is partially blocked, clean it.
J
John HaleyAug 21, 2025
Why is my jobmate YLQ6331G-150B Pressure Washer pressure fluctuating?
- U
  ulewisAug 21, 2025
  Fluctuating pressure in your Jobmate Pressure Washer can be caused by a pump sucking air, so check that hoses and connections are airtight. Another cause can be valves that are dirty, worn out, or stuck, so clean and replace them. Also, pump seals may be worn out, so clean and replace them.
N
nathaniel90Aug 28, 2025
Why does the fuse blow on my jobmate YLQ6331G-150B Pressure Washer?
- S
  Sherry DaviesAug 28, 2025
  The fuse might be blowing in your Jobmate Pressure Washer because it is too small. Change to an installation higher than the amp consumption of the machine and try using it without the extension cord.

Summary

Technical Data

Symbols Used to Mark Instructions

Important Safety Instructions

Name of Parts

Product Description

Assembly

Operation

Correct Use of Standard Accessories

Describes correct usage of adjustable nozzle and jet adjustment.

Recommended Cleaning Procedure

Instructions on applying detergent and rinsing surfaces for effective cleaning.

Storage

Procedures for switching off, draining, and preparing the unit for storage.

Maintenance

Trouble-Shooting

Circuit Diagram

Disposal

Warranty Policy

2 Year [Replacement;Repair] Warranty

Details the 24-month guarantee for home DIY use, void if used professionally.

Rights & Remedies

Outlines the warranty against defects in material and workmanship for two years.

What Do We Require?

Proof of purchase is required for all warranty claims; return to base policy applies.

What Is Not Covered Under Warranty?

Excludes professional use, misuse, accidents, poor maintenance, unauthorized servicing, and claims outside the purchase country.