9
3. 2 Make sure the front wheel will not rub the brake pads
when it is rotating under the condition of not pinching
brake handle.
4.1 Install the front fender and headlight on the front fork
with matching screws and nuts by a 4# hexagon wrench.
Make sure the front fender and headlight support cannot
be moved.
4.2 Adjust the headlight to a proper angle by this way:
loosen the adjusting bolt with with the 8# wrench, adjust
the headlight tilt angle to the best position, and then
tighten the bolt.
4.3 Connect the cable plug to the headlight, please note to
Step 4 Install the front fender
and headlight
To Next Page
Loading...
