8
Assembly Instructions
Step 1 Unpack the bike
Open the package and take out all of the parts.
Be careful of not missing even a little piece of part.
The parts shall include:
3.1 Place the front wheel in the correct position of the fork
groove and tighten it with matching quick release. (if there
are any hub protection parts attached to the wheel, remove
them)
Install the handlebar to the stem and fix it with matching
screws by a 4# hexagon wrench. During installation, adjust
the handlebar to an appropriate angle so that the bicycle
can be operated comfortably. Make sure the four screws are
tightened enough and the handlebar cannot be moved.
Step 2 Install the handlebar
Step 3 Install the front wheel
•
Front Wheel
•
Charger
•
Toolkits
•
Keys (2 identical)
•
Front Fender
•
Headlight
•
Quick release
•
Pedals
•
E-bike frame
•
Display
To Next Page
