balanced;
Whether the refrigerator parts are properly placed.
7.1 Warm ps:
The refrigerator enclosure may emit heat during operaon specially in summer, this is caused
by the radiaon of the condenser, and it is a normal phenomenon.
Condensaon: condensaon phenomenon will be detected on the exterior surface and door
seals of the freezer when the ambient humidity is large, this is a normal phenomenon, and the
condensaon can be wiped away with a dry towel.
Buzz: Buzz
will be generated by running compressor specially when starng up or shung
down.
8. TIPS FOR ENERGY SAVING
Try not to open the door too oen, especially when the weather is wet and hot. Once you open
the door, close it as soon as possible.
Every now and then check if the appliance is suciently venlated (adequate air circulaon
behind the appliance).
In normal temperature condions, please arrange the ther
mostat at the middle seng.
Before loading the appliance with packages of fresh food, make sure they are cooled to ambient
temperature.
Ice and frost layer increase energy consumpon, so clean the appliance as soon as the layer is 3-5
mm thick.
If it is the outer condenser, the rear wall should be always clean free of dust or any impuris.
The appliance should be located in the coolest area of the room, away fro
m heat producing
appliances or heang ducts, and out of the direct sunlight.
Let hot foods cool to room temperature before placing in the appliance. Overloading the
appliance forces the compressor to run longer. Foods that freeze too slowly may lose quality, or
spoil.
Be sure to wrap foods properly, and wipe containers dry before placing them in the appliance.
This cuts down on frost build-up inside the appl
iance.
Appliance storage bin should not be lined with aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulaon, making the appliance less ecient.
Organize and label food to reduce door openings and extended searches. Remove as many
items as needed at one me, and close the door as soon as possible.
9. DISPOSAL
Old units sll have some residual value. An environmentally friendly method of disposal will
ensure that valuable raw materials can be recovered and used again. The refrigerant used in your