Caution! Before troubleshooting, disconnect the power supply. Only a
qualified electrician of competent person must do the troubleshooting that
is not in this manual.
Important! There are some sounds during normal use (compressor,
refrigerant circulation).
Mains plug is not
plugged in or is loose
Fuse has blown or is
defective
Mains malfunctions are to be
corrected by an electrician.
Appliance freezes
too much
Temperature is set too
cold or the appliance
runs at “6" setting.
Turn the temperature regulator
to a warmer setting temporarily.
The food is not
frozen enough
Temperature is
properly adjusted.
Please look in the initial
Temperature Setting section.
Door was open for an
extended period.
Open the door only as long as
necessary.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
Turn the temperature regulation
to a colder setting temporarily.
The appliance is near a
heat source.
Please look in the installation
location section.
Heavy build-up of
frost on the door
seal.
Door seal is not air-tight.
Carefully warm the leaking
sections of the door seal with a
hair dryer (on a cool setting). At
the same
time shape the warmed door
seal by hand such that it sits
correctly.
Check the appliance and level it
by some articles.
The appliance
touching the wall
other objects.
Move the appliance slightly.
A component, e.g. a
pipe, in the side of the
appliance is
touching another part of
the appliance or the
wall.
If necessary, carefully bend the
component out of the way.
If the malfunction shows again, contact the Technical Assistance.
These data are necessary to help you quickly and correctly. Write the necessary
data here, refer to the rating plate.
To Next Page
Loading...
