There is a rotating brush in the floor nozzle. The brush must be cleaned if it becomes covered in hair or
other substances.
CLEANING THE BRUSH OF THE FLOOR
1. Switch the appliance off.
2. Detach the floor nozzle from the appliance by
loosening the mounting screw at the back of the
connector on the floor nozzle and sliding off the
floor nozzle.
3. Turn the floor nozzle upside down so that you
can see the rotating brush.
4. Remove hair, fibers and dust from the brush.
Use scissors to cut hair from the roller brush.
5. Reattach the back of the floor nozzle so that the
screw holes fit together and press it into position
until a click is heard, Make sure, the two parts fit
tightly all the way round.
6. Screw back all the screws.
Due to our program of continuous product improvement and innovation, sometimes the product you buy
may differ slightly from the one shown on this product carton.
-22-
To Next Page
Loading...
