Jocel JSBS014627 - Page 56

56
• The unit shall be kept away from damp locations where water is present. Water or dirt should be
removed from any surface of the unit as soon as possible using a soft cloth. This will help prevent
rust and will help your unit run at peak efficiency.
• Place the Side by Side in a well-ventilated place, reserve a certain space around and behind the
Side by Side, and do not cover or block the air grille on the rear cover plate of compressor at the
back of refrigerator; Keep the Side by Side away from heat source or direct sunlight.
ADJUSTABLE PLASTIC FEET
• When the Side by Side stays in the packing box, plastic feet are in tightened state. After carrying
it out from the packing box for placement, please make sure to adjust two front plastic feet until
the height is suitable; just adjust two plastic feet with a wrench or directly by hand.
• Plastic feet and rear rollers must touch the ground to prevent the Side by Side from movement,
vibration or noise. When moving the Side by Side, adjust plastic feet counterclockwise to keep
them off the ground, and then push the Side by Side gently to move it.
DOOR RACK
• Disassembly: Hold both sides of the door rack with both hands. Push it from the side without the
guide and push it inward as seen in the diagram. Push until the edge of the door rack is separated
from the grove of the liner.
• Installation: Hold both sides of the door rack with both hands. Install the buckle of the guide side
at first. Then push the other side inward slightly, the guide will then click into place and the door
rack will be installed. Please make sure it is installed properly before use.