Safety
DX,FLUID -19-12OCT11-1/1
DX,WW,HPCR1 -19-07JAN03-1/1
DX,WW,ACCLA2 -19-22AUG03-1/1
Avoid High-Pressure Fluids
Inspect hydraulic hoses periodically – at least once
per year – for leakage, kinking, cuts, cracks, abrasion,
blisters, corrosion, exposed wire braid or any other signs
of wear or damage.
Replace worn or damaged hose assemblies immediately
with John Deere approved replacement parts.
Escaping fluid under pressure can penetrate the skin
causing serious injury.
Avoid the hazard by relieving pressure before
disconnecting hydraulic or other lines. Tighten all
connections before applying pressure.
Search for leaks with a piece of cardboard. Protect hands
and body from high-pressure fluids.
If an accident occurs, see a doctor immediately. Any fluid
injected into the skin must be surgically removed within
a few hours or gangrene may result. Doctors unfamiliar
X9811 —UN—23AUG88
with this type of injury should reference a knowledgeable
medical source. Such information is available in
English from Deere & Company Medical Department in
Moline, Illinois, U.S.A., by calling 1-800-822-8262 or +1
309-748-5636.
Do Not Open High-Pressure Fuel System
High-pressure fluid remaining in fuel lines can cause
serious injury. Do not disconnect or attempt repair of fuel
lines, sensors, or any other components between the
high-pressure fuel pump and nozzles on engines with
High Pressure Common Rail (HPCR) fuel system.
Only technicians familiar with this type of system can
perform repairs. (See your John Deere dealer.)
TS1343 —UN—18MAR92
Service Accumulator Systems Safely
Escaping fluid or gas from systems with pressurized
accumulators that are used in air conditioning, hydraulic,
and air brake systems can cause serious injury. Extreme
heat can cause the accumulator to burst, and pressurized
lines can be accidentally cut. Do not weld or use a torch
near a pressurized accumulator or pressurized line.
Relieve pressure from the pressurized system before
removing accumulator.
Relieve pressure from the hydraulic system before
removing accumulator. Never attempt to relieve hydraulic
system or accumulator pressure by loosening a fitting.
Accumulators cannot be repaired.
TS281 —UN—15APR13
10-12
070717
PN=31
To Next Page
Loading...
