To Next PageTo Next Page
Need help?Do you have a question about the John Wood JW6 F307 and is the answer not in the manual?
General| Brand | John Wood |
|---|---|
| Model | JW6 F307 |
| Category | Water Heater |
| Language | English |
Owner's duties for proper installation, operation, and maintenance.
Lists required codes and standards for oil-burning equipment installation.
Warns about fire and explosion hazards from flammable liquids and vapors.
Alerts to the danger of severe burns from hot water.
Advises on the risk of carbon monoxide poisoning from poor combustion.
Specifies the need for certified temperature and pressure relief valves.
Details the approved fuel type for the water heater.
Instructions for safely removing and inspecting the water heater.
Guidelines for selecting a safe and suitable installation site.
Specifies required distances from combustible materials for safety.
Requirements for the oil tank, piping, and fuel supply components.
Instructions for installing the oil burner by a qualified technician.
Details necessary combustion and ventilation air for safe operation.
Guidelines for connecting the vent system to remove exhaust gases.
Information on selecting and installing the correct vent pipe.
Best practices for connecting to a chimney for safe venting.
Explains the function and installation of the draft regulator.
Instructions for installing the safety switch for vent blockage detection.
Information on optional power venting systems.
Requirements for connecting the potable water supply.
Guidance on connecting water inlet and outlet pipes and fittings.
Recommends mixing valves to reduce scalding risk.
Addresses thermal expansion issues in closed water systems.
Details the importance and installation of the T&P relief valve.
Explains the function of vacuum relief valves to prevent siphoning.
Step-by-step guide for replacing the aquastat control.
Requirements for the electrical connection and safety.
Procedure for filling the tank with water before operation.
A final check to ensure all installation steps are completed.
Steps to safely start the oil burner and water heater.
How to adjust the thermostat for desired water temperature.
Detailed steps for adjusting the water heater thermostat.
General operation, common sounds, smoke, odor, and anode rod issues.
Tasks requiring a qualified technician for servicing.
Regular checks the owner can perform for safety and efficiency.
Procedure for draining and flushing the tank to remove sediment.
How to test and maintain the T&P relief valve.
Guidance on inspecting and replacing the anode rod.
Steps to replace a washer in the drain valve assembly.
Specific cleaning steps for the flue passages of a model.
Instructions for safely shutting down the heater for vacation.
Procedures for safely restarting the heater after a shutdown.
Requirements for installing the water heater in combo heating systems.
Section to record installation details for future reference.
Section to record service history for future reference.
