To Next PageTo Next Page
Need help?Do you have a question about the John Wood JW717 and is the answer not in the manual?
General| Power Source | Electric |
|---|---|
| Frequency | 50Hz |
| Protection Level | IPX4 |
| Voltage | 220-240V |
| Water Inlet | G1/2" |
| Water Outlet | G1/2" |
Details user obligations for proper installation and care.
Lists applicable codes and authorities for installation.
Warns about fire and explosion hazards from flammable liquids.
Warns about severe burns from excessively hot water.
Warns about the dangers of carbon monoxide gas.
Specifies requirements for temperature and pressure relief valves.
Alerts to potential explosion risks, including hydrogen gas.
Warns about potential cancer hazard from airborne fibers.
Instructions for safely unpacking and inspecting the unit.
Guidelines for selecting a safe and appropriate installation location.
Requires bracing and anchoring for seismic zones.
Specifies minimum distances from combustible materials.
Details compliance for oil tank, piping, and burners.
Emphasizes professional installation by a qualified technician.
Provides a diagram and table for installation clearance requirements.
Illustrates installation dimensions for different models.
Explains the need for adequate combustion and ventilation air.
Details requirements for vent and exhaust system connections.
Discusses vent pipe system requirements and recommendations.
Outlines requirements for chimneys used for venting.
Explains the function and installation of the draft regulator.
Details the installation of the blocked vent safety switch.
Instructions for installing a power venting system.
Covers water supply requirements and pressure considerations.
Guides on installing water piping and fittings correctly.
Discusses the use and installation of mixing valves.
Explains thermal expansion and the need for expansion tanks.
Details the function and installation of the T&P relief valve.
Specifies requirements for the T&P valve discharge line.
Step-by-step guide for replacing the aquastat.
Covers electrical wiring requirements and safety.
Instructions for filling the tank with water before operation.
A checklist to ensure all installation steps are completed.
Step-by-step instructions for starting the water heater.
How to adjust and maintain the water temperature.
Discusses normal operation, sounds, and odors.
Explains short draws and their effects on water temperature.
Describes common sounds during operation.
Explains initial smoke and odor during startup.
Addresses water odor issues and anode rod function.
Regular maintenance tasks for the owner.
Instructions for periodic draining and flushing of the tank.
How to test and maintain the T&P relief valve.
Procedures for inspecting and replacing the anode rod.
Steps for replacing washers in valves.
Detailed cleaning procedure for flue passages.
Instructions for shutting down the heater for vacations.
Steps to safely restart the heater after a shutdown period.
Requirements for installing heating modules with the water heater.
Section for recording installation details.
Section for recording service history.
