DANGER
WARNING
CAUTION
NOTICE
CAUTION
DANGER
Indicates a hazardous situation that, if not avoided, could
result in death or serious injury.
Indicates a hazardous situation that, if not avoided, could
result in minor or moderate injury.
Indicates information considered important, but not
hazard-related.
2
FOR SERVICE ASSISTANCE, CALL 800-433-0708 OR VISIT JOHNDOW.COM
GETTING STARTED
CAPACITY AND DIMENSIONS
U.S. ENVIRONMENTAL REGULATIONS
Product Specication JDI-6EV JDI-20EV
Tank Capacity 6.5 gallons (24.6 liters) 20 gallons (75.5 liters)
Overall Dimensions - H x W x D (in) 35” x 16” x 15” 38” x 19” x 21”
Overall Dimensions - H x W x D (cm) 89 x 41 x 38 97 x 48 x 53
Weight (Empty) 32 lb (14.5 kg) 50 lb (22.7 kg)
Air Supply Pressure (Evacuate Fluid into Drain) 100-120 PSI (6.9 - 8.2 MPa) Max.
Air Supply Pressure (Evacuate Drain) 10 PSI (0.7 MPa) Max.
• Hot motor oil removed from the engine may exceed 220°F and cause severe burns or injuries.
• Opening a hot system can cause these uids to be forcibly sprayed in all directions.
• Allow oil temperature to reach 194°F or less before extracting.
• Do not exceed 120 PSI (8.3 bar) supply pressure when generating the vacuum.
• Never exceed the MAX vacuum reading on the vacuum gauge.
• Wear proper personal safety equipment. Use extreme care when handling to prevent burns or injury.
• Do no leave the bowl unattended while creating the vacuum.
• Do not use if vacuum gauge is damaged. Replace immediately.
• Tank should be in good condition with no visible leaks. Repair leaks and clean up spills and properly dispose of
waste material.
• Monitor uid level in bowl and on drain. DO NOT overll.
• Closely monitor the ow out of the discharge hose to prevent spills when evacuating oil from the drain.
• Inspect all hoses and probes before use for cracks, kinks, damage, or blisters. Replace damaged hoses or
probes immediately.
• Close all valves when the oil drain is not being lled or emptied.
Before assembly, ensure you have all parts according to the components list below. If any parts are missing or
damaged, contact us for replacement.
General Information
Read equipment manual and this material before using this tank.
• Certain automotive uids are considered to be compatible for recycling used oil per the US Environmental
Agency (EPA). Other types of uids may not be mixed with used motor oil and must be handled separate-
ly. See denitions below:
Used Oil Includes:
• Snythetic Oil
• Engine Oil
• Transmission Oil
• Brake Fluid
• Hydraulic Oil
Cutting/Metal Oils
Used Oil Does Not Include:
• Antifreeze
• Gasoline
• Kerosene
• Petroleum Distillates and Solvents
• Vegetable or Animal Oils
To Next Page
Loading...
Need help?
General