ISTISJCEBLC200 0.0
Installation Instructions
LC-200/BLC-200
1
2012/19/EU
LC-200/BLC-200
IR DETECTOR
1. INTRODUCTION
LC-200/BLC-200 detectors are the best choice for residential and commercial security installations: BLC-200 is not UL/ULC listed.
They only use digital PIRs which bypass the conversion that usually must be done with traditional detectors where an analog PIR is amplified and converted
to digital. The FULLY digital technology helps the detector more accurately detect intrusions and not be affected by alterations in white light, ultraviolet light,
temperature, air movement caused by heating/cooling systems, and it is fully immune to radiated and conducted electromagnetic interference. LC-200/BLC-200
detectors are equipped with lenses designed by Johnson Controls and are manufactured by Fresnel Technologies, Inc.
LODIFF
®
optic creation technology combined with POLY IR
®
materials make it a product of the highest quality and efficiency.
LC-200/BLC-200 detectors are pet immune (feature not evaluated by UL/ULC) and have a 15-meter range at a 100-degree angle.
2. INSTALLATION
- Using a thin screwdriver, loosen the bottom screw and open the cover (see Fig 1)
- Remove the board from the base by levering the ABS cover (see Fig 2)
- Drill the stopper on the base of the cover at the desired fastening location (or use the optional swivel that is not IMQ certified)
- Open the knockout for the removal protection and fix the anchor to the wall (see Fig 2)
- Recommended height is 2 m
- Slide the cable in through the back slot and out the top hole
- Wire the terminals following the connections shown in“Connection and Setup”
- Fig 1 -
- Fig 2 -
Ultraviolet Stabilization
POLY IR
®
4 Lens Material
The lens is printed with POLY IR
®
material.
This materials offers a better combination of
transmittance, environmental stability and color
than any other polymer on the market. Materials
are available for the 8-14 micron infrared region.
LODIFF
®
and POLY IR
®
are registered trademarks of
Fresnel Technologies, Inc.
LODIFF
®
Fresnel Lens Technology
This lens series is made by tiling LODIFF
®
lens pieces.
These lenses offer significantly improved performance
over the typical constant-bandwidth Fresnel lens.
LODIFF
®
and POLY IR
®
are registered trademarks of
Fresnel Technologies, Inc.
High RFI Protection
The detector has very high RFI immunity due to the
complete lack of traditional amplifiers.
White Light Protection
The detector digitally filters white light components.
Pet Immunity
Thanks to a new lens design and the digital analysis
system, all of our detectors are immune to pets
weighing up to 15 kg.
Fully Digital PIR
The detector has no analog components, and
the fully digital PIR interfaces directly with the
microprocessor.
NOTE: Do not partially or completely cover the detector's field of vision
NOTE: the pet function is not IMQ certified
Anchor
Jumpers DIP Switch
To Next Page
Need help?
General
