EasyManua.ls Logo

Johnson Hardware 1510 Series User Manual

Default Icon
1 page
Page #1 background imageLoading...
Page #1 background image
Question and Answer IconNeed help?

Do you have a question about the Johnson Hardware 1510 Series and is the answer not in the manual?

Johnson Hardware 1510 Series Specifications

General IconGeneral
BrandJohnson Hardware
Model1510 Series
CategoryAccessories
LanguageEnglish

Summary

Install Pocket Door Frame

Install Pocket Door Frame following normal instructions, including drywalling around opening. Carefully measure height "A" (from floor to bottom of frame header). Cut 11/16" x 4 9/16" Strike Jamb to this length.

Install frame, measure height 'A', and cut strike jamb to length according to instructions.

Open Door and Cut Split Jambs

Open door fully (door will protrude into opening) and cut split jambs to "B". Fasten to front edge of frame. Maintain minimum 3/16" clearance on both sides of door. Raise or lower hangers to plumb door with split jambs.

Open door, cut and fasten split jambs, ensuring 3/16" clearance and plumb.

Shim and Plumb Strike Jamb

Shim and plumb strike jamb (wide piece) with door.

Shim and plumb the strike jamb using the door as a guide.

Cut and Fasten Split Headers

Carefully cut split headers to "C". Determine side of hangers with lock arm and fasten this header with screws for easy removal. Nail other side. Here, too, maintain 3/16" on each side of door.

Cut split headers to dimension 'C', fasten one side with screws, nail the other, maintaining 3/16" clearance.

Fasten Bottom Door Guides

Fasten bottom door guides so that door stays in center of pocket, yet travels easily without binding.

Secure bottom guides to ensure smooth, centered door movement without binding.

Finish with Casings

Finish with your choice of casings (not included).

Apply chosen casings to complete the installation, ensuring a 1/4" reveal.

Related product manuals