Johnson Hardware 100FD 100FD Series User Manual

Lists the different 100FD series set numbers and corresponding door sizes for selection.

Instructions for ensuring square corners, level header, and straight jambs before installation.

Cutting the track to fit the opening width and fastening it to the header.

Attaching the hinge halves to the doors at specified points using screws.

Fastening pivot plates to the top and bottom of the doors as indicated.

Securing the floor bracket to the floor at specified distances from the jamb.

Inserting pivots and hangers to hang the doors onto the installed track and floor bracket.

Mounting aligners on the back side of lead doors for 4-door sets.

Checking clearance, alignment, and making necessary adjustments for proper operation.

Drilling holes and attaching knobs to the doors at specified locations.

Adjusting the snubber to ensure smooth door closing and prevent impact.