Delay Editing
The Delay effect includes adjustments for the Delay Level,DelayTime, and Regeneration Parameters.
Rotating the Delay knob will adjust the Level of the delay in the currently active Preset.Pressing the Shift
button and rotating the Delay knob will adjust the Regeneration (number of repeats) of the Delay effect.
The Tap-It button is used to adjust the DelayTime (the length of time between repeats). Tapping this but-
ton synchronizes the repeats to the rate at which it was tapped.
Reverb Editing
The Reverb Level is the only Reverb parameter available for adjustment in the Top Level edit mode. Rotating
the Reverb knob will adjust the amount of Reverb added to the signal.
Compressor Editing
The Compressor provides smooth and transparent compression with the ability to adjust the Ratio,Gain and
bypass or activate the Effect. Pressing the Compressor button will turn the Compressor on and off.
Pressing and holding the Compressor button will access the Ratio and rotating the Data knob will change
the Ratio.Pressing the Shift button and then pressing and holding the Compressor button will access the
Compressor’s Gain Parameter and rotating the Data knob will adjust the Gain.
Noise Gate Editing
The Noise Gate is an extremely useful effect that stops noise from coming through your amp when you are
not playing.Pressing the Gate button will turn the Noise Gate on and off. Pressing and holding the Gate
button will access the Gate Threshold and rotating the Data knob will adjust the Threshold.Pressing the
Shift button and then pressing and holding the Gate button will access the Noise Gate’sAttack Time.The
Attack Time can then be adjusted by rotating the Data knob..The Attack Time is the length of time it takes
the Noise Gate to open once you begin playing.
To Next Page
Loading...
Need help?
General