Johnson Poker - How to Use as Mincer or Mixer; Cleaning Instructions

13
- Press the START button (B) avoiding con-
tinuous operation for periods longer than
25 seconds. Release the button at intervals
to allow the motor to cool and rest.
If the appliance overheats after continuous
use, let it rest for 10 minutes until it cools
down completely.
- Disconnect the plug from the power ou-
tlet after use. Disassemble and clean the
whisking shaft and motor section before
putting the appliance away or before be-
ginning a new processing.
HOW TO USE AS MINCER OR MIXER
- Insert the appropriate accessory into the
container (H):
Blade (F) to mince or chop.
Disc (E) to mix or blend.
Place the accessory on the pin located at
the bottom of the container.
- Place the food to process in the container.
Do not put too much food in the container
so that food does not spill out of the con-
tainer when the appliance is running.
- Put the lid (I) on the container.
Align the small triangle of the container
with the left triangle of the lid and then
click into place by turning in a clockwise di-
rection.
- Assemble the motor section (A) to the
container (H) with the lid (I). Align the small
triangle on the upper part of the lid to the
triangle of the motor section. Press down
and turn in a clockwise direction.
- Insert the plug into a compatible power
outlet.
- Press the START button (B) avoiding con-
tinuous operation for periods longer than
25 seconds. Release the button at intervals
to allow the motor to cool and rest.
If the appliance overheats after continuous
use, let it rest for 10 minutes until it cools
down completely.
- Disconnect the plug from the power ou-
tlet after use
- With the plug disconnected, remove the
container and retrieve the processed food.
Disassemble and clean the parts before
putting the appliance away or before be-
ginning a new processing.
CLEANING
After each use, disconnect the plug and
clean all the appliance parts.
Clean the motor section (A) with a soft and
slightly damp cloth.
Do not immerse the motor section in water
or other liquids.
Clean the accessories with water and soap,
rinse and dry well before putting away or
reusing.
Do not use solvents, diluents, alcohol or
abrasive sponges.