24
COMPONENTS
A Brush protection cover
facial cleaning
B. Facial cleansing brush
C. Hair shaving accessory
nose / ears
D. Accessory for finishing sideburns / mu-
staches
E. Protective cover of the foils
F. Foil with 3 rotating heads
G. On / off button
H. Percentage of battery charge
I. Battery symbol
J. Padlock symbol
K. Cleaning reminder
L. Shaver socket for small plug
M. Cleaning brush
N. Adapter
O. Small plug
P. Pouch
Q. Adapter socket
R. Large plug
S. Display
T. Foil group opening button with
3 rotating heads
U. Head seal support knob
V. Head support
Z. Rotating head notch
W. Rotating Head Support Tab
After removing all the components of the
men’s beauty set from the box and che-
cking that they have not been damaged,
proceed to use. In case of obvious product
anomalies, contact an authorized service
center or contact the retailer, do not use
the appliance.
CHARGE
The recommended ambient temperature
for charging is between 5 ° C and 35 ° C.
Charging of the battery may not be com-
plete or may not be fully charged in extre-
mely low or high temperatures.
Do not expose the appliance to tempera-
tures above 50 ° C for prolonged periods
of time.
Check that the appliance is turned off. In-
sert the end (O) of the power cable into the
shaver socket (L) while the other end (R) of
the cable insert it into the adapter (N) so-
cket (Q). Once the operation is completed,
insert the adapter plug (N) into an electri-
cal outlet suitable for receiving it.
The battery charge percentage (H) flashes
and the battery symbol (I) lights up on the
display (S) to indicate that the device is
charging.
When the battery is fully charged on the
display (S) the percentage indicates 100
without flashing and the battery symbol (I)
goes out.
With fully charged batteries, use the unit
until it discharges (before completely di-
scharging the battery symbol (I) lights up
on the display (S) and starts flashing), then
recharge to full capacity.
Full recharging can guarantee up to 2
hours of autonomy of use without cable.
(see fig.1-2-3)
ACCESSORIES ASSEMBLY
Make sure that the appliance is turned off
and unplugged from the power socket.
Select the desired accessory, and proceed
to insert it on the body of the appliance,
making sure that all the couplings match
each other.
Make sure that the accessory is well fixed
to the body of the appliance (there must
be no gaps between the accessory itself
and the unit, and this must be firmly and
firmly). (see fig. 4)
REMOVAL OF ACCESSORIES
With the appliance turned off and discon-
nected from the power socket, to remo-
ve the mounted accessory, simply exert a
slight pull towards the outside (high) until
the accessory detaches from the appliance
body. (see fig. 5)
REMINDER FOR CLEANING
For optimal shaving performance it is re-
commended to clean the appliance after
each use.
ATTENTION: when the symbol of the clea-
ning reminder (K) lights up in solid white,
it is necessary to thoroughly clean the ap-
pliance.
(see fig. 6)
To Next Page
Loading...