25
TRAVEL BLOCK
When the device is packed in the suitca-
se, it is possible to activate the operation
lock to prevent the unit from accidentally
turning on.
To access the function, press the on / off
button (G) for 3 seconds. While the tra-
vel lock is activated, the corresponding
padlock symbol (J) lights up and flashes
on the display (S). Once activated, the
padlock symbol (J) goes out.
To deactivate the travel lock, press the on
/ off button (G) for 3 seconds, the padlock
symbol (J) on the display (S) lights up and
flashes. Once deactivated, the padlock
symbol (J) goes out. (see fig. 7)
The device is now ready for use again.
N.B. it is only possible to deactivate the
travel lock with the device connected to
the electrical distribution network.
SHAVING
The best shave is achieved with dry skin.
Preferably shave before washing or some
time after washing.
Turn on the appliance by pressing the on
/ off button (G).
Quickly pass the rotating heads over the
skin. Perform both linear and circular mo-
vements.
Spread the skin with your free hand, in
this way the hair is lifted and you get a
closer shave.
The skin may take some time (on average
2 to 4 weeks) to adapt before it completely
gets used to the shaving system.
Press the on / off button (G) to turn off the
appliance, and cover with the protective
cover (E) to prevent damage.
N.B. it is possible to use the appliance even
if it is unloaded, by connecting it directly
to the electrical distribution network.
Do not use the appliance if the rotating
shaving heads (F) are damaged.
(see fig. 8-9-10)
ACCESSORY FOR NOSE / EARS
This accessory is used for nose and ears.
After turning on the appliance by pressing
the on / off button (G), it is sufficient to
introduce the head (C) carefully inside the
nostrils and / or ear canal to quickly adjust
or remove unwanted hair from these areas
that are difficult to do. reachable.
When the operation is completed, turn off
the appliance by pressing the on / off but-
ton (G).
N.B. do not insert the head too deeply into
the nostrils and / or ears, to avoid damage
or injury (maximum 5 - 6mm.).
(see fig. 11-12)
ACCESSORY FOR FINISHING
SIDES / MUSTACHE
After turning on the device by pressing the
on / off button (G), use the accessory (D) to
finish cutting sideburns and / or whiskers
with the highest possible precision.
When the operation is completed, turn off
the appliance by pressing the on / off but-
ton (G). (see fig. 13)
FACE CLEANING ACCESSORY
Moisten the facial cleansing accessory (B)
with water and apply the cleanser on the
face. Alternatively, you can moisten the
accessory (B) directly with the liquid deter-
gent.
Do not use the appliance with the accesso-
ries (B) dry, as it can irritate the skin.
After turning on the unit with the on / off
button (G), place the accessory (B) on the
skin and start the treatment.
Gently pass the brush over the skin in cir-
cular motions. Do not press too hard, the
treatment must be pleasant.
Don’t overdo the cleaning and don’t stay
on the same area for more than 20 secon-
ds.
Once the treatment is finished, turn off
the appliance with the on / off button (G)
and cover the brush (B) with the protective
cover (A).
N.B. the accessory (B) was designed and
manufactured for cleaning the face and
neck, excluding the sensitive area around
the eyes.
For reasons of hygiene, we recommend
that you do not share the appliance with
other people.
Do not use the brush (B) on chapped or ir-
ritated skin, on open wounds or in the pre-
To Next Page
Loading...