32
INSTALLATION
INSTALLATION
Vehicle Belt or ISOFIX
straps
must always be secure
and pulled tight.
See pages 9 –11
Carry Handle
must always be locked
into position.
Tether Strap
must always be used when the
restraint is installed in a vehicle.
Store end of tether in bag.
See page 19 - 21
Base Recline Adjustment
base must be reclined correctly
See pages 7 & 8
Secure Latching
restraint must be
securely latched
into base.
See page 17
Read the whole of these instructions carefully and if there
is any doubt about the method of installation, consult the
child restraint manufacturer or agent, or a child restraint
fitting station authorized by the relevant transport authority,
or in New Zealand an agent for the vehicle.
Overview
• Use the restraint exactly as shown in the instructions.
• Fit the restraint firmly to the car seat.
• A loose harness or restraint is dangerous.
• Destroy the restraint if it has been in a severe crash,
even if no damage is visible.
• Do not alter or modify this restraint.
• Repairs must only be done by the manufacturer or
agent.
• DO NOT USE A REAR FACING CHILD RESTRAINT
WHERE AN AIRBAG IS FITTED IN FRONT OF THE
SEATING POSITION.
• Only use this restraint with the base it was supplied
with. If a second or replacement base is required it
must be a matching model number.
WARNING
NOTE: The warnings on these pages are those
required by the Australian and New Zealand
Standard AS/NZS 1754 for this type of child
restraint. Other warnings specific to this
particular child restraint will be found throughout
these instructions.
IMPORTANT: Also read the following instructions carefully
To Next Page
Loading...
Need help?
General