Joie traver - 3-Point Belt Installation and Usage; Shoulder Belt Routing; Belt Placement Under Armrests; Correct Head Support and Belt Positioning

13 14
! Could also be installed by using 3-point belt only.
(see images
19
-
23
)
!
Position shoulder belt through the shoulder belt guide
shown in
19
-1
!
DO NOT position vehicle belt over top of the armrests. It
must pass underneath the armrests.
19
-2
!
The booster can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the booster
securely.
19
-4
!
After your child is placed in this booster, the safety belt
must be used correctly, and ensure that any lap strap is
worn low down, so that the pelvis is firmly engaged.
19
31
2
4
19
!
To ensure the correct head
support height is obtained, the
bottom of the headrest MUST
be even with the top of child’s
shoulders as shown in
20
and
the shoulder belt must be
positioned in the red zone as
shown in
21
!
Place a booster firmly against
the back of a forward-facing
vehicle seat equipped with a
lap/shoulder belt.
!
Have your child sit in a booster
with their back flat against
back of a booster.
!
Fasten buckle and pull up on
the shoulder belt to tighten.
22
(Wrong installation.
23
)
!
If the belt lays across child
neck, head or face, readjust
head support height.
!
Belt must not be twisted.
22
23
20
21