Jolly logic AltimeterOne - How to Operate the Altimeter; Turning the Altimeter On; Clearing the Display for Next Flight; Turning the Altimeter Off

Use the AltimeterOne’s button to turn it on, clear it for the next ight,
and turn it off.
Turning It On
Press the button once quickly to turn the display on before every ight.
It will display the last altitude measured.
Clearing the Display
Hold down the red button until you see “OOOO,” then release it. The
display should now say “O,” and it is ready for the next ight.
Turning It Off
Press the red button once to turn the display off. The system will also
automatically turn itself off 60 minutes after the last ight peak was
recorded.
Using the Button
Reading the Display
Peak altitudes higher than 9,999 feet are shown in thousands of feet ,
and are indicated with a decimal point in the display.
1215 = 1,215 feet
12.15 = 12,150 feet
jolly logic
TIP
Although the button looks quite small,
you do NOT need a sharp object to press it.
Just put your entire nger tip over it and press
until you feel a “click.”
3