5
SETUP
insulation. Do not use the device in
case of defects or serious damage
9. Do not connect any power sources to
4C size battery holder except C size
batteries, or it may damage the unit
You have two options to get your de-
vice started. Your unit came with an AC
adapter. Remove the back cover from your
device and plug in the adapter. You will
see an opening at the bottom of the unit
that you can run the cord through. If you
don’t have an electrical outlet available
in the area, you will need four C batteries
(not included)
When you install power, a red light will
turn on after a few moments. The light will
stay on for about 20 seconds and then
switch off. Your device is now ready to use
All of your controls are located at the back
of your device. Remove the cover to adjust
the following settings as needed
To Next Page
Loading...