6
GUIDELINES
1. With batteries, set the Ultrasonic
switch to Motion Sensor. Doing so will
considerably prolong the battery life.
Set the Motion Sensor Sensitivity to
20-25 for smaller animals (squirrels,
mice, birds) and 15-20 for larger
animals (dogs, raccoons, deer)
2. When plugged-in, use Constant, as
it provides the best protection for
repelling a specic type of animal
3. If you need to repel several types of
animals, set the switch to Continuous
Sweep; the device will then random-
ly cycle through a whole range of
frequencies
4. It’s advised to leave the unit operating
24HR. However, if required, change
the switch to Night (Nocturnal Ani-
mals) or Day (All Animals)
5. If you don’t want to hear the device,
turn the Sonic Volume all the way
down to zero
6. Find the animal category you want to
repel on the frequency dial and point
the knob at the arrow on the left side
of that category for birds, skunks, and
deer, and on the right side for rodents,
cats, dogs, and bats. Other animals
would fall somewhere in between.
Rabbits tend to respond to insects
category
To Next Page
Loading...