EasyManua.ls Logo

Jon-Don Prospector PE300 - User Manual

Jon-Don Prospector PE300
12 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Safety, Operation and Maintenance Manual
with Parts List
Please read before use!
300 PSI
Important Information and Safety Instructions
Register your Machine at www.jondon.com
Serial No:
© 2013 Copy Rights Reserved Jon-Don, Inc.
Prospector PE300 Extractor WIth Heat
REGISTER
YOUR
MACHINE
ONLINE!
Reliable Power
Innovative Design
Safe & Easy to Use
Powerful Extracting
Easy Transport
Patented Features
Model No. PE300

Table of Contents

Questions and Answers

  • J
    Jennifer LambAug 11, 2025
    Why is my Jon-Don Scrubber vacuum weak?
    • P
      petersonkatieAug 11, 2025
      A weak vacuum in your Jon-Don Scrubber can occur for several reasons: * The vacuum tank might be full, in which case you should empty it. * The float assembly tank screen could be dirty; clean it with water. * The float ball may be stuck; tap it to unstick it, then clean it. * A vacuum hose might be damaged or loose; attach or replace it. * The dump valve could be open; close it. * The access lid might not be sealed; replace the gasket. * The vacuum hose could be clogged; clear any debris. * The air intake grid could be clogged; clean it. * There might be a leak in the recovery tank; clean and dry the area, then patch it with silicone. * Water might be coming out of the vacuum exhaust; use a low-foaming detergent.
  • T
    Theresa DavisAug 19, 2025
    What to do if my Jon-Don Prospector PE300 won't turn on?
    • C
      christopher87Aug 19, 2025
      If your Jon-Don Scrubber won't turn on, consider the following: * Ensure the extension cord is properly plugged into both the machine and the outlet. * Check that the switch is in the “On” position, and replace it if needed. * The building circuit might be overloaded; try resetting the circuit. * Loose wiring connections could be the issue; unplug the machine and inspect for any loose wires.
  • L
    Lisa MayoSep 2, 2025
    Why does my Jon-Don Scrubber have a burning smell?
    • L
      Lisa ParkerSep 2, 2025
      A burning smell in your Jon-Don Scrubber could indicate that the vacuum motor or the pump motor is hung up. If this is the case, replace the vacuum motor or replace the pump.
  • T
    tmooreNov 26, 2025
    What to do if my Jon-Don Prospector PE300 pump is not running properly?
    • J
      Jaclyn HillNov 26, 2025
      If the pump in your Jon-Don Scrubber isn't running correctly, here are some things to check: 1. Make sure there's power going to the pump by checking the electrical system. 2. Clean the jet filters, as the jets on the wand might be clogged. 3. Clean the in-line filter, as it might be clogged. 4. Clear any debris in the solution tank that might be covering the inlet. 5. Check for any kinks or looseness in the hoses, and replace them if necessary. 6. Snap quick disconnects together, as they may not be completely locked. 7. Flush the heater with a system maintainer or replace it if necessary, as it might be clogged with deposits. 8. Check for clogged jets and clean them if the pump is pulsating. 9. Close the valve, as the auto-prime valve might be open. If these steps don't resolve...

Jon-Don Prospector PE300 Specifications

General IconGeneral
BrandJon-Don
ModelProspector PE300
CategoryScrubber
LanguageEnglish