INTRODUCTION
Operator's manual
The initial language of this operator's manual is English.
Operator's manuals in other languages are translations from English.
Overview
No. Description
1 Warning
2 Before charging, read the instructions
3 Indoor use only. Do not expose to rain. Do not leave, store or use in the
rain or in wet conditions.
4 Time lag fuse
5 Battery charger
6 Power cord (A = inlet, B = plug)
7 LED - Battery connected
8 LED - Error
9 LED - Battery temperature
10 LED - Battery charging
11 LED - Battery charge complete
12 LED - Read battery manual for error code
OPERATION
a WARNING: Read and understand the IMPORTANT SAFETY
INSTRUCTIONS chapter before you use the product.
To connect the battery pack charger
• Connect the battery pack charger to the voltage and frequency specied on the
rating plate.
• Use the provided power cord.
• The LEDs on the product ash once.
To connect the battery pack to the battery pack charger
• Make sure the battery pack is dry before it is connected to the product.
• The battery pack will not be charged if the internal battery pack temperature is
over 45°C (113°F). This causes the product to actively cool down the battery
pack.
NOTE: The battery pack charger must be connected to the voltage and frequency
specied on the rating plate.
1 Insert the power cord into the inlet on the charger.
2 Insert the plug of the power cord in a grounded socket. The LED on the battery
To Next Page
Loading...