Need help?Do you have a question about the Jonsered LT2119A and is the answer not in the manual?
General| Engine Manufacturer | Briggs & Stratton |
|---|---|
| Cutting Height Adjustment | Lever |
| Cutting Height, min-max | 38-102 mm |
| Transmission | Hydrostatic |
| Number of Blades | 2 |
| Fuel Tank Capacity | 5.7 l |
| Wheel Size | Front: 15 inch, Rear: 18 inch |
Guidelines for safe operation, including reading manual, adult operation, clearing area, and avoiding hazards.
Precautions for operating on slopes, focusing on up/down mowing, slow speed, and avoiding tip-overs.
Rules for keeping children safe and out of the mowing area during operation.
Safety guidelines for performing maintenance and repairs on the tractor.
Critical warnings regarding starting, coasting, towing, and general tractor operation.
Information on chemicals in engine exhaust and batteries, and associated health risks.
Steps for setting up the tractor, including battery check and seat installation.
Definitions of DANGER, WARNING, CAUTION, and HOT SURFACES indicators.
Detailed description of each control lever, pedal, and switch.
General guidance on operating the tractor safely and effectively.
Steps for setting parking brake, stopping, using throttle, choke, and controls.
Guide on how to engage and operate the mower deck.
Specific safety precautions and procedures for mowing on slopes.
Essential checks and preparations before starting the engine.
Procedures for starting the engine in both warm and cold weather conditions.
Steps to warm up and purge the transmission for optimal performance.
Advice for achieving the best mowing results and maintaining the mower.
A schedule outlining regular service intervals for tractor components.
Essential checks to perform before operating the tractor each time.
Common causes and corrections for a tractor that fails to start.
Troubleshooting steps for a tractor that is difficult to start.
Solutions for when the engine does not crank or turn over.
Diagnosing issues when the engine only makes clicking sounds.
Identifying and fixing causes of reduced engine power.
Resolving issues with the operator presence control system.
Diagnosing and fixing problems resulting in an uneven grass cut.
Causes and solutions when the mower blades fail to spin.
Troubleshooting issues related to grass clippings not being discharged properly.
Identifying and correcting problems causing loss of tractor drive.
Addressing engine backfiring issues upon shutdown.
To Next Page
